Add to Favorites   |   Set Homepage
Home   |  About Us   |  News   |  Products   |  Network   |  Message   |  Contact Us
Product List
New Arrivals
Planes Stuff
Boat Stuff
Car & Tank
EDF
FPV Stuff
RC Propellers
RC Simulators
Tx/Rx Parts and Systems
Tools/Equipment
Brushless Motor
Lipo Battery
Lipo Charger
Speed Controller
Servos
RC Spares And Accessories
RC Electronics
Toys
Single-side PCB Board Series
Cable Products Series
Wire and Cables
DC Motor
AC Motor
 
      Product Search     
Home > Product List > Frsky FASST-compatible TFR6 receiver

 
Overview >>
1.Introduction
1.1 Compatibility:
FASST 2.4G: Air Systems (7CH Mode/Multi Mode)
FrSky TF Modules: TF-8M, TF-14M

1.2 Specifications:
Number of Channels: 7
Operating Voltage Range: 3.5V~10V
Dimension: 37*22*8mm
Weight: 7.8g

1.3 Features
1) Lighter weight and physically smaller;
2) Two selectable failsafe setting options.

2.Setup
2.1 Bind procedure:
Turn on the transmitter, connect the battery to the receiver while pressing receiver’s F/S button. After the RED LED is off and GREEN LED is solid, the binding process is completed and the receiver is operating normally.

2.2 Setting failsafe:
TFR6 support two selectable failsafe setting options, either use native failsafe position preset on the transmitter side, or set failsafe on TFR6.
2.2.1 Use native failsafe position preset on the transmitter side:
If not disabling failsafe on the transmitter side, TFR6 will use native failsafe position preset on the transmitter side.

2.2.2 Set failsafe on TFR6:
TFR6 supports failsafe function for all channels. Follow the steps below to set failsafe on TFR6:
1) Bind the receiver first, and disable failsafe on the transmitter side;
2) Set all transmitter controls to the desired failsafe position;
3) Press briefly the F/S button of the receiver, the GREEN LED of the receiver will flash twice, indicating the failsafe is set up successfully.
If you do not need the failsafe function any more, just re-bind the receiver to set default failsafe mode.
Hint: If not disabling failsafe on the transmitter side, TFR6 will use native failsafe position preset on the transmitter side.

2.3 LED status:
RED LED GREEN LED Mode
Off On Normal mode
On On Waiting to be bound
Flashing On Signal lost
On Flashing twice Set failsafe
 
 
 
Next:Corona RP6D1 Synthesized Dual Conversion Receiver 6Ch 35Mhz
Previous:Frsky FASST-compatible TFRSP receiver
 
Home   |  About Us   |  News   |  Products   |  Network   |  Message   |  Contact Us
Copyright:Hobby Great Wall Co.,Limited Address:No 801, Gate 5, Liren Garden, Hudai Town, Wuxi City, Jiangsu Province
Tel:86-510-85591634 Fax:86-510-85591634 E-mail:hobbygreatwall@126.com Web:www.hobbygreatwall.com   Sitemap   
外贸网站:Kogin